I am planning to put together a low tech "water change system", and wanted to get some input because I am a plumbing newb.
I am planning to put staging water in a rubermaid tote, and then have a release valve (probably ball valve) which will allow gravity to take the water down to my "mixing tote".
My question is around parts and sizes.
3/4" Bulkhead for tote hole? Silcone to prevent leaks?
3/4" Ball Valve?
3/4" barbed connector?
vinyl tubing.
Can I connect the ball valve directly to the bulkhead? or do i need some separation?
Any other ideas that are probably much better than mine? Missing parts?
I am planning to put staging water in a rubermaid tote, and then have a release valve (probably ball valve) which will allow gravity to take the water down to my "mixing tote".
My question is around parts and sizes.
3/4" Bulkhead for tote hole? Silcone to prevent leaks?
3/4" Ball Valve?
3/4" barbed connector?
vinyl tubing.
Can I connect the ball valve directly to the bulkhead? or do i need some separation?
Any other ideas that are probably much better than mine? Missing parts?