Search results

Good line. Going to use this next time. :D

I haven't bought a used car for many years. My minivan is 14 years and the sedan is 12 years old. I am the buy and drive it to the ground type of guy. If I want a luxury car I will lease one. Buying a 5 year old Mercedes you will end up with expensive repairs. A luxury car is not necessarily a...

Actually had to take some layers off once start hiking. Not bad at all if you're prepared. There was no supermodels, but there was this afterwards:

I loved BB but after watching Homeland it's the now best show ever for me. Especially season 4.

Mark your tank and sump look VERY nice. And nice stand too.

Having used Red Sea and base on your dosing method and salt I think the Red Sea is close to correct. CA is super-saturated in the aquarium water it would be almost impossible to not see a lot of precipitation at these levels.

It is cold but enjoyed the hike in the snow.

Paul - where can I find this mag/ca relationship? This makes it important to check mg levels as we try to maintain ca level @ ~420 ppm.

Alk has been in the 7.1 to 7.7 range. I have been increasing the dosage. I dose similar amount of calc (a little less) as Alk. The few times I check calc was about 400. I check Alk almost daily. I have not add any new coral to the tank for at least 1 month now. I wonder if it would eventually...

Mag is 1100. Have not tested for a long time. So it's low. Used to get 1500+. But I doubt it's the reason. Spreading out from one point like a virus. Coraline on the rocks is ok.

Have you seen this before? Water parameter is good and corals are doing good. Started from the center then spreading for about 5 days now. At the spreading edge there is some mucus.

natureef style denitrator.

Paul - the bulkhead already has a seal on one side but the other side is just plastic. I was careful to tighten then usually but I wasn't thinking this morning. Anyways I lost my confidence in this and will use a 20g instead.

This really sucks now. Holes were drilled good but cracked the tank when tightening the bulkhead. :mad: And just glue the bulkhead in too.

I am but you're too far.

Thanks Earl. That makes me feel a little more comfortable.

I have a frag tank as well (although not yet running). I have the sump 2ft off the fl and the frag tank 3ft off the fl.

Try to reduce the head by setting up the sump higher. My setup has 10 ft head and only use about 50 watts. And agree with the flexible PVC much easier to run and fewer 90 degree elbows means less head loss.

Need to clear the frag rack. All frags are very encrusted unless otherwise noted. $15 Strawberry short cake War favia Sunset mille (fresh cut) $10 Setosa Purple nana Tyree fire chalice Bird of Paradise (fresh cut)

I need to drill a hole for 1 inch bulkhead in a 10g tank and my first attemp failed. The glass cracked when it was drilled. Bought another tank and taped the drill area and this time it was perfect. Now I am a little worried that the thin glass of a 10g tank cannot handle the water pressure long...