Help with Jebao DCP-2500

[UsamaCh.]

So I’m using the jabeo dcp-2500 return pump with sine wave technology. The lowest we are able to set it to is FO30. Then it just displays PO10. The instructions are not really clear as we try to “unlock” the controls but nothing happens.

Basically does anyone have any experience with setting these pumps up and how to work the controls that can help. I suspect the pump isn’t on a constant speed. Appreciate any and all help!

 

[UsamaCh.]

We have the same pump on another system that’s displaying PO11.

 

[Versys47]

P is the power being used and F is the speed setting.

g. Normal operating mode is with PXXX shown on LED (P is short for power). There are 71 settings for speed. When touching up/down buttons, the LED will indicate the current speed setting (FXX). You can set speed ranging from 30% to 100% in 1% increments. After more than 1 second with no press of the +/- button, the display will revert to Watts display

https://www.theaquariumsolution.com/sites/default/files/downloads/DCP%20Pumps%20Operating%20Instructions.pdf

 

[UsamaCh.]

P is the power being used and F is the speed setting.

g. Normal operating mode is with PXXX shown on LED (P is short for power). There are 71 settings for speed. When touching up/down buttons, the LED will indicate the current speed setting (FXX). You can set speed ranging from 30% to 100% in 1% increments. After more than 1 second with no press of the +/- button, the display will revert to Watts display

https://www.theaquariumsolution.com/sites/default/files/downloads/DCP%20Pumps%20Operating%20Instructions.pdf

So the speed can’t go below 30%?

 

[Versys47]

My DCP 10000 will not go below 30. Must have to do with it being easy to stall at lower speed settings than 30.