i don't own a table saw and my scoring ability has made more waste than anything. I was looking to make this skimmer http://www.nano-reef.com/forums/index.php?showtopic=58540&st=280 post # 297 . Any acrylic wizards out there??? PLease help a reefer in need.
-
Folks, if you've recently upgraded or renewed your annual club membership but it's still not active, please reach out to the BOD or a moderator. The PayPal system has a slight bug which it doesn't allow it to activate the account on it's own.
need help cutting some acrylic for a nano skimmer
- Thread starter medachef
- Start date
In the past when I needed to cut acrylic sheets I have used a wet tile saw,makes clean cuts and the plastic shards dont fuse to the sheet...or maybe a jigsaw may work...hope this helped some 
where are you located??
next week I'll be building my sump for my new tank
your welcome to come by and I'll cut it for you
I'm in vernon NJ near mountian Creek
next week I'll be building my sump for my new tank
your welcome to come by and I'll cut it for you
I'm in vernon NJ near mountian Creek