Recent content by Hitman

Sorry, but you did not answer my question. The question was how do I tell if my memory is high density, not whether it makes a difference. Now you obviously know more about computers than I, but in the past I've taken advise from people who are knowledgable about computers only to have them be...

Does anybody on this site stay on subject?

Congratulations! ;D ;D ;D As everyone said, she's a cutie.

Chances are if it's a fixture for a DE bulb the glass is the proper type to filter out the UV.

I have a 250 over my 30 gallon and it is more than enough light, your tank is 6" deeper and 6" wider front to back. With the right reflector you should be OK. You need UV protection on DE bulbs, Se bulbs have it built into the Glass of the bulb itself.

UMMMMMMMMMMMMM, look above your last post! ;)

Whenever I diagnose before defragging it tells me it's not necessary, but i do it anyway, so i don't think I need to do it more often. I thought I said this before, but I don't see it, I defrag and run a full error check biweekly. I also have the latest patches for PSP11. Ed, No CD yet, How...

Paint Shop Pro 11 When I go to save the file I'm working on, it takes forever. 3 Gig Pentium 4 XP2 upgraded whenever a new upgrade comes out

Actually the ones I'm looking at are cheap enough that I would consider swapping them both out with 1G sticks. It is a 7200RPM HD.

I have yet to see a LFS drill a hole without first telling you they are NOT responsible for anything that happens, in other words if it breaks, don't blame us!

This pic might help. The Green arrow is the level of the tank, the Orange arrow is the level in the OFB. You should make sure your tank is topped off when you make your adjustment, otherwise it might not get enough flow through the OFB after evaporation. In this pic the water level is right...

Is the water level in your overflow a bit lower than the level in the tank? If not I have noticed that the surface water will not or barely be pulled into the box. If this is the case try raisng your overflow a little bit at a time until the level in it is about 1/8" below that of the tank.

It did'nt tell me if it's High density or not.

Thanks for the link. I do have a program called Belark Advisor which gives me all the info in my PC, but it only gave me this info on the memory sticks, "502 Megabytes Installed Memory Slot 'J6H1' has 256 MB (serial number 0xFFFF7055) Slot 'J6H2' is Empty Slot 'J6J1' has 256 MB (serial number...

I'm working on the flyer for the fall frag swap and the program i bought to make it is running slower than I can deal with, I'm hoping it is not enough memory. regardless of this I want to add at least 1G, I currently only have 512. I know it's 3200DDR, but I don't know if it's high density or...