Search results

sounds like it is too deep in the water.. my 250 sits in 8-10" of water at all times then i adjust the wedge pipe for control of the water level.. try turning the 90 a little so theres not much back pressure and check your depth

If you had the room but it sounds like you don't, i would go with Lumenbrights.. If not Lumenarc Minis with or without the uv glass would be the way to go. the lumenarc minis - Dimensions: 14.5” L x 14.5” W x 6.5” H

10-4 will do

I would go that way just because i'm lazy and it's much easier to make something fit than build new.. Hence why when i put my canopy back together i used 2-1/2" screws.. I think the canopy did well for holding a 220gal tank on top for 150 miles or so

the 220 has dual overflows.. right now i only have the right side plumbed to the pump because i was going to get a second pump to power the left side. I think that if i use two MAG 18's it will be too much flow

the only way to raise it is open the ball valve off the pump line which reduces the flow back to the DT. maybe i'll pick up a piece 7"X17" and plumb both sides of the return into the pump.

what about using your current hood? if your competent enough to make a full canopy you can surely make some sort of rack or something to mount those tubes a little lower..

whats the measurements where you have room?14.5 will fit some lumenarc minis. Can you count the Reflectors at the top of the canopy and then mount the tubes just under them as far over as possible.. Kinda like Marc L had (melev)? http://www.melevsreef.com/pics/0704/2outof3_flash.jpg...